LayersFactory
Zgłoś model
1 / 5
Dell Optiplex 7040 SFF Hard Drive Caddy — zdjęcie 1
1 / 5

Dell Optiplex 7040 SFF Hard Drive Caddy

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

S3

S3

@shadow3_1908516

5 Bay HDD caddy for the Dell Optiplex 7040 Small Form Factor desktop to maximize storage capacity potential

Ocena
0 / 5
Polubienia
6
Pobrania
47
Wydruki
0
Wyświetlenia
962
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (12)Wydruki i komentarze (Wydruki: 0) (Komentarze: 4)Remiksy (0)Kolekcje (15)Powiązane

Lots of time spent to get fitment right and some sanding will be needed…

The whole idea is to densify hard drive storage space in a small form factor machine that can be used as a NAS or network area storage server on the cheap. There is enough space to mount 4x 2.5" drives at 9.5mm and 1x 3.5" drive at full ~26mm height and still close the case (tight though).

Only 25Divider_Top should need supports although the 25Divider_TopAdapter might benefit also. All other models were designed to eliminate the need for supports.

These models assemble together with M3 brass inserts, screws, nuts and washers. The assembly file and photos are included to see how all parts go together. The entire assembly should be able to mostly drop in. 

Assembly:

  1. Press brass inserts into all respective holes with solder iron

  2. Attach all Drive Platform standoffs using screws through the Drive Platform from top and into screw inserts in standoffs.

  3. Attach 25Divider using screws through Drive Platform from bottom, through thru-holes on 25Divider_Bottom, and into screw inserts on 25Divider_Top

    1. Note: 25Divider_Bottom is directional due to screw hole spacing on 2.5" drives. Double check orientation.

  4. Align 2.5" drives with ports to long flat side of Drive Platform, aligning the mounting screw holes to the mounting cones of the 25Divider. Align respective 25sidePSU or 25sidePwrSw (power switch) mounting cones and screw sides to Drive Platform from bottom.

  5. Attach 25Divider_TopAdapter with two screws through front of 25Divider_Top and two nuts inserted into TopAdaptor from the back.

 

Complete NAS build notes:

  • 7040 SFF only has 3 SATA ports. Extra PCIE to SATA card was used.

  • 7040 SFF only has 1 full SATA power connector. 6 way SATA power splitter used. 

  • Recommend 7mm 2.5" drives for best cooling capability.