1 / 4
NerdQAxe++ VReg Clip and 60mm Fan Mount — zdjęcie 1
1 / 4

NerdQAxe++ VReg Clip and 60mm Fan Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

NerdQAxe++ Vreg heat sink clip w/ 60mm fan mount

Ocena
0 / 5
Polubienia
6
Pobrania
45
Wydruki
0
Wyświetlenia
727
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This mount attaches to the top holes above the headsink. I added it after upgrading to a liquid cooler. I included a Vreg heat sink clip that works with the heat sinks I bought off Amazon titled “3D Printer Heatsink Kit”  https://www.amazon.com/dp/B07RKHRHJV?ref=ppx_pop_mob_ap_share (not an affiliate link) which just holds the sinks in place. One end of the clip attaches to the end of the board while the other hooks under the fan mount. Printed in PLA but if you plan to get your VREG very hot you might want to use PTEG for the heat sink clip. (Added non-fan mount bar file if you don't want the fan mount)

Note this will cover the screen so relocating the screen is recommended unless you don't care 😅

Use m3 4-6mm long bolt to attach through pub holes.

I Printed with fan grill on bottom with tree supports.

 

Updated to add a v2 version with better side support and air channeling