Reduced size Penrose kite and dart half triangles (requires glue)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are similar to other Penrose tiles in my collection, split into kite and dart halves. Assembly requires glue.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Puzzles & Brain-teasers
- Licencja
- Creative Commons — Attribution — Share Alike
These are similar to some other designs such as Checker Penrose tile triangles, Penrose tiling based on flippable triangles and Flippable Robinson triangles but I have reduced the size significantly. You can see the photos comparing them in size to a US dime.
Assembly requires glue to permit overhangs for tabs that fit into corresponding tabs. I have supplied frames for gluing top and bottom tiles. The bottom half goes in first, upside down and the top half goes on top of it right side up. Attach with a very small amount of superglue (cyanoacrylate). Very little is needed to hold them well. I have found that too much will seep into the gaps leaving less room to push in the tabs.
See reduced size “einstein” tiles for photos of how to glue these together. The approach is the same. Glue them bottom to bottom so both the tabs and gaps are on the inside layer as in this side view. 
The photos show larger layouts of tiles. They are liftable but a bit fragile. I have to admit that these are not as much fun to assemble as the larger snap-fit tiles. I just wanted to see how small I could go using glue.