Fnirsi DPO350P Protection Corners

There are two versions: 

1. hard surfaced with some slots to the silicone pads (dampers) 8mm (diameter) x 2mm (height), (_pads postfix).
2. tpu rubber version without silicone pad slots, because the whole corner will work as damper, (_rubber postfix)

Each hard surface corner may take up to 5 pads per corner, but you may attach it without silicone pads.

Anyway, I'd recommend to use at least 2 pads per corner: 1 - front face to protect the screen and 1 - on the diagonal face here from the rear side, so it wouldn't slip while the original support leg is open. 

Each corner is connected to oscilloscope body with 2 screws: 1 side screw is the original one, with a hex socket, 1 rear exotic screw, 2.2mmх25mm DIN 7981. It's really hard to find this long m2.2 screw. I thing that m2.2, m2.3 or m2.5 screw diameter will fit ok and I'm afraid that m2.6 will destroy the plastic thread on the body part, however m2.6 is much easier to find 25-30mm long. But you could try your luck in this lots, for intsance: 

https://aliexpress.ru/item/1005004104251761.html

https://aliexpress.ru/item/1005003240338775.html

I think that if oscilloscope will fall down accidentally (hope it will never happen) this corners will be smashed. I hope so! In that case they will act like destroyable springs, so you could print another ones :)

For the hard surfaced corners I'd recommend PLA, PETG, ABS, ASA filaments, and for the rubber one - TPU filament. But it's up to you what filament you will to choose.

I'm not taking any responsibility if you will destroy your oscilloscope anyhow with this corners application, do it on your own risk.