Centered mount for PlanetBike MicroMite 2.0 Mini-Pump
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount to hold a PlanetBike MicroMite 2.0 Mini-Pump in line with the bike frame, either bolt mounted or using zip-ties.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 93
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
The Planet Bike MicroMite 2.0 mini bike pump comes with a mounting bracket to hold the pump alongside a water bottle, but it only works to hold the bike pump off to the side of the bike. If you want to carry your pump in-line with the bike frame, you can print out this mount instead. There are two versions: one that mounts either with the standard mounting bolts in place of a water bottle cage or with zip-ties, and a smaller version without the bolt holes that only mounts using zip-ties.
Either version should be printed in PETG or ABS filament (PLA will eventually creep under pressure and lose its grip on the pump), using at least 3 walls. The bracket should be printed standing on one end (so the layer lines wrap around the pump for maximum strength). Support and a brim are needed, but use “Support on build plate only”, as supports within the zip tie channels will be impossible to remove (and are not needed for the zip tie channels or the bolt holes).
If mounting with zip-ties, you will need two 3mm wide zip-ties, and may want to glue a small piece of spare innertube to the back of the pump-mount for traction, so it can't slide around.