1 / 4
Givi PL539 Adapters for 2005 Suzuki Bandit 650S (GSF650S K5) — zdjęcie 1
1 / 4

Givi PL539 Adapters for 2005 Suzuki Bandit 650S (GSF650S K5)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A set of adapters, spacers, and lighting mounts for the 2005 Bandit 650S to mount Givi PL539 luggage racks

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
234
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

The Givi PL539 does not seem to quite fit the 2005 Bandit 650S. These models are what I have printed and used on my own motorcycle to get the luggage rack to mount. I have printed these models in nylon at 265C for better heat resistance and strength. The indicators are more than 180mm apart still so it should pass an MOT.

Extra Hardware

You will need an extra M6x30 (or longer) bolt and nut. Optionally also an M6 washer and lock washer. You will need M6x65 or longer for the license plate extension, M6 nuts, and washers.

I needed to solder 100mm of extra cable to the rear indicators to get them to reach the wiring harness.

Print as many spacers as you need, I ended up using 6 of each size. 

You should use thread lock to avoid vibrating things loose.

Instructions

Remove the license palte and the metal mount that it screws into. Print the license plate extension and put it between the metal mount and the tail where it screws in, then use some M6x65 or longer bolts to screw the extension and mount on there.

Print the indicator relocator and remove the rear indicators from their mounts on the tail of the motorcycle. Note which color connector they were using on the wiring harness (for me it was grey on the left, black on the right). This is where I added 100mm of extra cable to them. Using the original backing plate and nut fit the indicators to the printed mount the same way as they would have done in their original place on the tail making sure the left and right are not swapped.  The 3d printed mount will fit between the license plate and the license plate mount using the same screws. Run the wires the same way they were going originally and connect them to the wiring harness.

The spacers included with the PL539 and monorack arms were the incorrect size for me. I made smaller spacers and used as many as I needed to get the perfect length. I used 1 spacer between the frame and the monorack arms, then 2 spacers between the monorack arms and the PL539 at the pillion grab handle.

On the right side near the exhaust the support for the PL539 did not reach the screw so the right foot extension has long holes to adjust the spacing and connect the two together.

Tagi