Fairphone 6 bike holder

This is a remix of CyberCyclist's bike phone holder for iPhones made to fit a Fairphone 6 without a case. The fit is snug and the phone is very secure inside of it, I tried thrashing it about as much as I could and it never fell out. For now I made it fit the Fairphone 6 without a case or any accessory, but I'm planning on adding files for a version that can hold it with the official case and potentially the card and finger holder accessories when they arrive.

I really like this phone holder design as it's extremely secure and doesn't budge at all, it's main disadvantage is the fact you have to reprint the main holder for each new phone and even when adding or changing cases, which is inconvenient, but I think worth it.

I made the holder shorter so you could still reach the power button, but the volume down button isn't really accessible (I can get my finger in there if I try tho).

The tolerances were honed in for my printer, but your mileage may vary (especially since mine is of questionably quality, but it should probably be fine).

Only the phone holder requires supports to print, turn them off for the rest. You can secure he base with zip ties, and put a rubber pad between it and the handlebar so it doesn't slip. You can tighten the zip ties pretty hard, I used as much force as I could to tighten them and nothing broke. I'd recommend PETG since this is intended to go outside, but I used PLA (the only PETG I have is bright green, which doesn't really fit), and it's been fine for now. The original Thingiverse model has a few pictures detailing how it all fits together so take a look there.

If you know Fusion 360, the original post has a file you can edit to create a holder for any phone, but idk how to use Fusion 360 so I did it in Blender.

Edit 1: I realised I accidentally shortened the clip on the back of the holder. It still worked relatively well but wasn't as secure as it should be. It's fixed now.