Anker Power Bank Tripod Mount

I needed a way to hold my Anker PowerBank onto my tripod that wasn't zip ties while I record 4k60fps soccer matches. My phone would regularly go from 100% to 5% during a single match, often times i would lose the footage if it died before i stopped recording. This was a great solution, since i can run a long charging cable from the PowerBank up to the phone at the top of a 5m tripod.

• the clamp is made to fit around a 32mm pole (just slightly larger than 1.25in)

the only thing you'll need are (2) ¼ -20 socket head cap screws. The threads printed out on my X1C perfectly, although you may want to chase them with a tap.

I printed in ABS-GF with standard print settings with the following exceptions:

• supports enabled (build plate only)
• 4 walls
• 15% infill - Gyroid

I printed the “rear” of the clamp on its back and  the front of the clamp was standing upright. This was to ensure the threads printed correctly. The supports were only needed at the two side tabs on the front clamp.