Shimano Altus Cantileverbremse Federgehäuse/Shimano Altus cantilever brake spring housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Federgehäuse, rechte und linke Seite Spring housing, right and left side
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Beim Erneuern der Bremsbeläge ist mir das Federgehäuse der Shimano Altus Cantilever Bremse zerbrochen. Kein Wunder, die Bremse ist schon über 30 Jahre alt. Deshalb gab es im örtlichen Handel auch kein Ersatzteil mehr dafür. Da das Rad aber am nächsten Tag wieder auf die Straße sollte, habe ich das Gehäuse neu konstruiert und auf meinem Prusa MK4S ausgedruckt. Es funktioniert einwandfrei und ich empfehle mindestens PETG als Material. Das Foto zeigt den Druck in PC blend. Das kleine Loch für die Feder ist etwas stramm, wenn die Feder zuerst von außen eingeführt wird, funktioniert die Montage von innen aber einwandfrei.
While replacing the brake pads, I broke the spring housing of the Shimano Altus cantilever brake. No wonder, the brake is already over 30 years old. That's why there was no spare part for it in the local shop. However, as the bike was due back on the road the next day, I redesigned the housing and printed it out on my Prusa MK4S. It works perfectly and I recommend at least PETG as a material. The photo shows the print in PC blend. The small hole for the spring is a bit tight, but if the spring is inserted from the outside first, mounting from the inside works fine.