Bicycle splash guard V2 superslim

A splash guard that extends the mudguard of your bicycle. It can significantly reduce the dirtying of the bottom bracket and parts of the drivetrain. No tools or modifications at the bike needed. There is a regular and a slim version.
There are 3 parts: 

• A clip that sits on the inside of the mudguard printed best in ASA or PET-G.
• The splash guard that is fixed with the hooks of the clip, printed in flexible Material.
• A splash guard test file to check whether the dimensions are correct without having to print the whole splash guard.

Preparation

• To adapt to your specific mudguards get Freecad and measure the height, width and thickness: 
  
• In Freecad, open the spreadsheet and adapt the red parameters:

• Mark each _export object and export the respective stl files
• You can print splash_test to check whether the dimensions are correct without having to print the whole splash guard.
• You can play around with the splash thickness for different flexible filament hardnesses and the splash stretch factor for a tight fit. You can print splash_test to check whether the dimensions are correct without having to print the whole splash guard.

Printing

• Layer height: 0.2mm
• No supports
• Infill: clip: 40%, splash guard: 15%
• The clip is best printed with weatherproof material as ASA, but PETG should be fine as well.
• The splash guard is printed in TPU with 96 Shore A hardness. Other flexible Filament should work as well.

Installation

• Make sure that your mudguards are mounted with enough clearance to the tire. Put the clip between mudguard and tire with the sharp edge facing down fitting closely the end of the mudguard. Hook the splashguard with the holes into the hooks of the clip.