Tivoli Audio Model One - On/Off Knob
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement knop for the on/off button of a Tivoli Audio Model One radio.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 398
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Tivoli Audio Model One – Replacement Selector Knob (3D Printed)
This is a replacement knob for the Tivoli Audio Model One tabletop radio.
The original selector knob (bottom center) controls Power / Source Selection (Off – FM – AM).
On my unit, the factory knob was missing/damaged, so I designed a 3D-printable replacement.
The model has been dimensioned to fit the shaft snugly while maintaining the clean, minimal look of the radio.
Features
- Designed specifically for Tivoli Audio Model One
- Fits the lower selector switch (Power / AM / FM)
- Simple and functional design, close in appearance to the original
- Easy to print (no supports required)
Printing Recommendations
Orientation: Print standing upright for best detail
Layer height: 0.2 mm
Infill: 15% is sufficient
Material: PLA or PETG both work well (PLA recommended for indoor use)
Notes
Depending on your printer tolerances, you may need to slightly adjust the shaft hole diameter by scaling. I printed mine in a light gray PLA to match the original radio design, but feel free to experiment with colors.