Armrest for Acoustic Guitar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shell that clips onto the bottom of a classical (or acoustic) guitar to create an ergonomic curvature to reduce strain.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 138
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Share Alike
Additional parts:
- M4 heat-set insert 6 mm in length.
- Hand-cut gasket or pad to match the inside of the flat semicircular area.
- Hand-cut gasket or pad to match the inside flat trapezoid on the clip.
- I make my gaskets from corkprene, but it may be possible to print TPU if you roll that way.
- Metric gnurled hex socket cap screw M4 between 25 and 35 mm in length (I got mine at my local True Value for about $1).
- Felt or suede to place on the three downward faces to prevent scratching the guitar.
- Adhesive for gaskets and pads (I use E6000).
- Matte acrylic spray for finish, optional
I print in PLA, with minimum 3 perimeters, Prusa Slic3r settings 0.2 mm QUALITY, support to build plate only. I print the shell with the flat front C-shaped part to the build plate. I print the clip with one side to build plate to get long-direction strength along the alignment pin. After printing I wet-sand the outer shell to 600 grit, because I want it smooth against the arm.
The design is for a 10 cm depth of guitar, in this case a Cordoba C3M. I extracted the profile by tracing the guitar's curve, but it will probably work on other guitars. If needed, the design file (FreeCAD) is included.