Voron 2.4 Blobifier Poop Chute
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Poop Chute to work with the Blobifier.
- Ocena
- 5 / 5
- Polubienia
- 71
- Pobrania
- 107
- Wydruki
- 4
- Wyświetlenia
- 1793
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Been working on this for a while on and off, pretty much has been working great for my setup. I had to change the files some to work for the standard bed layout for the 350mm 2.4 since my bed sits lower. Its also made for a 355mm and can use the standard Blobifier setup or the Fystec board. You will not need the switch for the bucket and will not use it, but you will have to have the connector coming out the bottom. Also you will have to cut out your deck to allow this to work(will try to work on a template). Will work with either the standard z motors/gearbox or with the G2Z/G2Z XL(there is a left skirt too). You will need to move your power switch/plug over so a middle skirt is included with a fan spot also if needed. All should print without supports.
EDIT 10/23: Update the poop_chute_deck_funnel to add support for the funnel tip. Added skirts to use with the G2Z/G2Z XL. Added full stl to preview how its setup.
If you want to help me out with buying some more filament to replace all that was used to create this.
Thanks so much.