Alt OM-120/RM-Based Siren Design
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An alternate take on the ACA OM-120 siren, using a modified RM-130 projector assembly.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 315
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a three part model. Use a 775DC motor, and install it on the proud face of the stator assembly. In the recess on the opposite side, install the rotor, with a 10MM OD/5MM ID set screw collar or shaft coupling pressed in to the hub. The rotor should spin freely and true, with no wobble. This is critical. Check and clear any interference in the air gap, and install the assembly on to the projector. Fasten the two together with M6 bolts, use a minimum of three bolts out of nine. With the entire assembly upside-down, thread the bolts in to nuts on the inside of the projector, which fit in to the hex-shaped recesses. These must be 10mm head size or smaller. Your siren is now finished. In the text document are links to the hardware I used, and a youtube video.