Motorcycle Throttle Tube 22/25,4 and 22/26 mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple motorcycle throttle tube for 22 mm handlebar. Two outer diameter options. Adjustable lenght for open-ended.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 359
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
My Yamaha XJ 650 needed a new throttle tube, and I couldn't locally find one that fits.
There's two lenghts and two diameters. You can stop the print at a point to get a custom-length open-ended tube. The tube fits 22 mm handlebar. Outer diameter options are 25,4 mm and 26 mm. The thicker one is obviously a stronger print.
The spacer is supposed to go between the grip and housing if using a grippy rubbery grip.
Printing
Print with PETG or some other engineering filament with good layer adhesion. Layer adhesion is critical for safety, as the tube needs to be printed vertically.
The throttle cable groove requires supports. I used organic on build plate only. I also used an organic support to support the top end, but I guess that was unnecessary.
Random seam is recommended. Use at least 3 perimeters.
Ream the cable end hole with a drill if it's too tight a fit.
Disclaimer and safety notice:
Print and use at your own risk. Test the strength of the print before use. Be mindful that should the print break along layer lines, your throttle grip may become loose. PETG may begin to soften at 70 degrees Celsius, bear this in mind when parking the bike for long periods in the Death Valley sun.