18650 holder for Fibox 175/75
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
18650 cell holder for the Fibox 175/75 series electrical boxes, with space for 68 cells. SMD fuse cutouts for 4s17p.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 907
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
18650 cell holder for the Fibox 175/75 series electrical boxes, with space for 68 cells. Probably also fits other 175-boxes. The same model can be used as both the top and bottom holder, and leaves about 2.5mm space on either side. Can be screwed to all 12 screw holes in the bottom of the electrical box, either directly with short screws or through both holders with long screws. I used no screws, and it has held up for 4 years by now.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 Plus
Rafts:
No
Supports:
No
Resolution:
0.15mm
Infill:
35%
Filament: PrimaCreator PLA white
Notes:
Recommend 35% infill or higher. Holes are tweaked to friction fit normal shrinkwrapped 18650s when printed using FDM. If printed using resin or another method that leaves a smoother surface, the holes may need to be shrunk slightly in order to achieve a good fit.
Suggested tweak: remove the battery pole collars on the negative side. Then cells are easier both to place correctly and replace later. I did this for my next battery build.
I've been using the batteries I built with this holder in an electric moped for several years now with no issues. It's dead solid.
Category: Electronics