Volvo V70 Door Lock Ring Snug Fit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a redesign of my own original Volvo Door Lock Ring optimized for a 0.4 nozzle and fitment.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a complete redesign, from the ground up in Freecad, of my original Volvo Door Lock Ring that has been optimized for printing with a 0.4 nozzle and snuger in-the-door fitment. Also, with more control, and a lot of practice, i was able to recreate a more accurate part to the original.
Reason? It turns out, leaving your car outside in the heat of summer has the unintended effect of annealing your printed parts, hence the new part with tighter fitment to the door, and more sturdy and effective retention.
Print Settings:
Printer:
Prusa MK4S
Enclosure:
Not necessary
Filament:
Tested with PETG
Layer Hight:
0.15
Infill:
N/A
Exterior Perimeters:
5
Brim:
Inner brim only
Brim width, about 1.3mm
Heated Bed:
Yes
Supports:
Yes
Snug
Approximated Filament Usage:
0.33 (m)
Approximated Print Time:
7 minutes on stealth