Stream Deck Stand for Epomaker TH80-X

This is a stand for the 5x3 button Stream Deck that attaches to an Epomaker THX-80 keyboard.  I remixed Gummientchen's great and simple model for attaching the stand to his Ducky One 2 to change the way the stand attaches to the back of the keyboard as there was too little room between the Function Keys and the case.  

This model:

• Hugs the top filet that goes around the keyboard
• Adds a notch for the cable that comes out of the top (at least on my model), which also locks the Stream Deck in place in the stand
• Adds a flat piece that lays on your desk and connects to a securing piece at the front of the keyboard case

Recommendations:

• Print on the side using supports
• 2-3 walls
• If the fit is a little loose, either shrink the under-keyboard arm by ~1mm or (like I did) use a small piece of mounting tape, which is made of foam and is typically double-sided.  This will “squeeze” the whole thing without putting too much pressure on the securing arms.  I imagine you could also use a small segment of TPU to accomplish the same thing.

This model:

• Hugs the top filet that goes around the keyboard
• Adds a notch for the cable that comes out of the top (at least on my model), which also locks the Stream Deck in place in the stand
• Adds a flat piece that lays on your desk and connects to a securing piece at the front of the keyboard case

Recommendations:

• Print on the side using supports
• 2-3 walls
• If the fit is a little loose, either shrink the under-keyboard arm by ~1mm or (like I did) use a small piece of mounting tape, which is made of foam and is typically double-sided.  This will “squeeze” the whole thing without putting too much pressure on the securing arms.  I imagine you could also use a small segment of TPU to accomplish the same thing.