Bambu Compatible Spool for Refills or Respools

I post two versions of spools:

1. One with full closed side which prints fastest.
2. Another with partly open sides. This in four colors, MMU or AMS needed.

The shims fit perfectly, I carried them over from original.

One crucial improvement is the arrangement of the 2 x 2 holes for the filament. Always when I start a new roll I drill the holes farther apart AND in an 45° angel. So the filament can be fiddled in easier and it does not break so easy!

Now some instructions for the Multicolor version:

I had to kill some old filament, so I printed the ring and disk in HIPS in different colors.

For the logo I printed (disk lying on heatbed!) the Bambu leaf in GREEN (0.6mm thick → 2 layers at 0.3mm LH or 3 layers with 0.2mm LH. Due to my 0.6mm nozzle I printed in 0.3mm LH. In order to have a brillant shiny green (here: translucent PETG) I have a second set of Bambu leaf in WHITE. Also 0.6mm height.

This means for 0.2mm LH (refer to the photgraphs!):

• Layer 1 = Black and Green
• Layer 2 = Black and Green
• Layer 3 = Black and Green
• Layer 4 = Black and White
• Layer 5 = Black and White
• Layer 6 = Black and White

For my inner RIngs I sacrificed Red HIPS.

Note: I like to point you to the Orange of the spool, this is already filament in Orange!

Explore my other Printables: https://www.printables.com/de/@Tritschi