X-Shot MPP Stock-ish Stock LiPo Meter Cutout
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaced one of the side pieces with a cutout to fit a generic LiPo alarm/meter.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 411
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print all of the original pieces for the Stock-ish stock, but only print one of the side mesh pieces. This replaces the other one. Top right corner of the cutout might not connect, but it doesn't really matter, you won't see it.
Fits generic lipo alarm that looks like this:

I did have to bend three of the pins for an 8s, 7s, and 6s towards the other pins for it to fit in this spot. You wouldn't ever use these pins for this anyway.
I also used a 2s balance plug extension to make wiring into the alarm easier. I hot glued while plugged into the alarm so that it wouldn't come off.

Basically just lined up the alarm to the cutout (pins facing down) and hot glued it on. Then, just hot glued the whole mesh piece into the stock.