1 / 2
POTA 33H mast guy sleeve — zdjęcie 1
1 / 2

POTA 33H mast guy sleeve

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

4 rope POTA 33H guy sleeve

Ocena
0 / 5
Polubienia
4
Pobrania
17
Wydruki
0
Wyświetlenia
161
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

this is a pota 33h 4 rope guy sleeve that goes on the first inner section. going up one section give it more stability. cuts down on filament use if you print it upside down for not having to print inside supports. printed on flashforge 5m with 40-50% infill. 

(yes, my print quality is bad used the last bit of a roll I've had for a while sitting out)