Voron 15x15mm camera mount modified arm

UPDATE 9/24/2025: The camera blur has mostly gone away now so maybe the camera just needed to get broken in or the focus was messed up?

UPDATE 9/7/2025: The camera has gotten blurry after only about a day of use printing at ABS chamber temperatures so I can no longer recommend buying this camera. It could be my unit is defective so if you still want to try it I will leave this model up.

The original arm from @Tijmenbo ‘s gantry camera mount design stuck out too far and was colliding with my stealthburner toolhead in my voron 2.4 and it was also rubbing against the xy joint. To fix this I shortened how long the arm protruded and then made the cylindrical part taller to avoid rubbing on the xy joint. I’m uploading this in case someone else is having the same issue. If you already printed the camera enclosure part then there's no reason to reprint because I only modified the arm.

Assembly is the same except I used a m3 16mm BHCS to screw into the m3 t nut in the extrusion

I bought my camera from here the 2.8 120 fov one: https://www.aliexpress.us/item/3256808435447530.html

The usb cable that is attached to the camera was too short to route all the way to my electronics bay, so I extended it with a usb female to male cable. Also, expect for the camera feed to get a bit grainy when your chamber is heated up. I will update the post if the camera ends up dying

I used this extrusion slot cover to hide the camera's usb cable https://www.printables.com/model/84741-motor-b-cable-cover-for-voron-24

The arm can be printed either flat or in the original orientation with supports. I found printing it flat didn't make the cylinder part too clean looking so I printed it upright and used the support painting fill for the underside of the arm