1 / 2
RigidBot Glass Corner
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This corner glues to a sheet of Borosilicate glass (from McMaster in my case) and makes the bed removable but still held down to the bed.
To print you'll need 4 of them - Mirror two of them and test fit. They're not symmetrical.
CA glue worked to glue them to the glass.
I realize this is of limited use to most people because you have to use the same glass from McMaster and still have the original Kickstarter bed on your RB1... but I'll leave it here anyway :)
Print Settings
Printer:
Dremel 3D45
Rafts:
No
Supports:
No
Resolution:
300um
Infill:
Doesn't matter
Notes:
These are PLA but anything should work.
Category: 3D Printer Accessories