AD5M nozzle and filament type identification

This mod is to help identify which nozzle and filament you have set up on your AD5M (non-pro). To avoid clogging I'm swapping the nozzle when changing from PLA to PETG. Both filament are printed at different temperature, going from one to the other with the same nozzle can cause clogging since a higher temperature filament can leave small piece and will stay in the nozzle because of the lower temperature. This system is handy to avoid error and help organize my workshop. 

Feel free to suggest improvement. This mod isn't compatible with AD5X yet. 

Limitation of this mod: I printed their parts using my AD5X (4-colors), if you only have a AD5M, you will need to manually swap the filament, however the printing time of the identification tile is around 10-12 min. so it's not very intensive. 

Additional materials

• Electrical tape/ double-face tape (optional)

Installation

1. Insert the base in the printer frame - optional put a tape between the base and the printer frame to make the base firm and avoiding it to vibrate when printing
2. Store your nozzle and extra identification in the storage part
3. When changing nozzle and filament, swap the identification tile
    

Print instructions

• Printer: since it's a flat 2-colors first layer it's recommended to use a multicolor printer like the AD5X
• Nozzle:  0.4 mm nozzle recommended (not bigger than 0.6 to have clear characters)
• Material: PLA or PETG
• Wall: 3
• Infill: 15% (but not really needed since the walls are small)
• Supports: you may need support for the base, otherwise no support
• Brim: strongly suggested for the storage part

Please share your print !