Pex Cinch Clamp Holder/Spacer

I was having trouble cinching down the fittings correctly and originally printed a “collar” (green in the image) that held the ring in place to be cinched. Unfortunately, in tight spaces it isn't easy to use it. So, I created a clip (white in the image) that serves the same purpose, but is much smaller. This clip fits onto the ring and holds it in place while it is cinched. 

I added a V2 of the spacers with a flat “back” because I was having trouble printing them on their side, because so little surface area was on the bed. 

Edit to add:
I tried these little clips on some Sharkbite brand cinch clamps and these clamps are a tighter fit. So the above clips will not work with these cinch clamps. So, I added my TPU holders. 
You can print them in TPU without support.
To use them, squeeze the “feet” and slide them over the cinch clamp when you have it on the pipe, then line it up with the end of the pipe and it should hold it there while the clamp is cinched.