Jeep Wrangler JK 1:10 / 6x6 Conversion / Bed / Rollbar / Fender 4x4 / Fender 6x6.... on TRX-6 Chassis

The parts are for the ABS HardBody, which is sold by Team Raffee, Injora, and various other Chinese labels (the PickUp version of the body). If you want to rebuild it and put it on a TRX6: I also have various TRX6 chassis parts here on printables which were made especially for this body. Almost everything requires significant cuts to the body.

General Description:

• L and R mean left and right. Some parts are only available for one side and must be mirrored in the slicer.
• All parts are designed for M3 screws.
• Screws cut their own threads into the holes (tight fit).
• In some parts M3 nuts must be pressed in.
• All printed in PLA+ with 15% infill. All parts are designed for support-less printing.

Parts  Description Fender:

• Versions for the normal 4x4 and my 6x6 conversion available.
• Both versions require cutting of the body, designed for 120mm tires.
• The rear 6x6 version consists of two parts. I glued them together.
• Use an M2 hexagon screws. Drill 1.5 mm holes and screw in directly.
• The rear fenders have a gap at the front that needs to be filled with the (wegde).

Parts  Description Extension:

• The body must be sawn in the middle of the rear wheel house.
• The lower and upper parts must be glued to the body.
• Some versions of this body have a cap over the wheel arches. This is what the cover part is for.

Parts  Description Bed:

• For the 6x6 conversion, the original bed has to be removed. I have a replacement for that.
• Front and rear are glued to the body.
• Can also be connected in the middle with the connecting part using M3 screws.
• Cutouts for the TRX6 shock towers are available.
• A spare wheel holder can be mounted on the connection point in the middle.
• There is a gap to the trunk lid for which a part (gap) is included; glue it in.

Parts Description Rollbar:

• Works for the 4x4 and 6x6 versions.
• Use the drilling template to precisely position the holes on the fenders. The edge with the corner is at the front edge of the 6x6 extension.
• The rollbar can be connected directly to the driver's cab at the original points (bar_body_connect).
• The rails above the fenders are optional but complete the design. For 6x6, use front and rear. For 4x4, only front.
• To prevent the rails from lying hollow, use the (pin).