Vintage Car Swamp Cooler

yes i got banned for this from 3D Printing Parts Group on FB. You can also follow me on youtube.com/id10tgarage.

Comment away with your suggestions

*NOTE, this is still a work in progress, i am testing as i upload it for fitment. Use at your own risk This can be sized to your desire, just don't do a uniform scale. Sit it on the bottom, and scale it up******

Window Mounted Swamp Cooler, Removable Hat for easy maintenance, add Ice to one side to keep it extra cool

8/28/2025:

• v4 Models - fixes thin areas and also adjust the Hat for a more snug fit
• Added 11mm Model, This is for window frames with a large cap on them

8/21/2025:

• Thin Walls currently on models in Vent and Window Attachment area. I will need to fix this, but still good test subject.

8/20/2025:

• Added a Cone for the skinny Cooler. Its meant to be glued to the rear to give it a more cone shape. 100% Cosmentic, mostly hollow

8/19/2025: Angle Mount - Very Much in TEST

Designed for strain relief on the top of the window

• Added Bottom Mount and W-mount versions of the design.
• Print the bottom mount nut side to the bed (1/4 x20) and a pause before the 1st layer that covers the nut. Insert your nut, then resume print..
• Requires 1/4" 20 Threaded Rod
• Bottom Mount Requires a M4 screw on Suction Cup for the Back. This goes on the glass https://www.amazon.com/AccEncyc-Suction-Sucker-Without-Bathroom/dp/B0BWM24F3G)
• For already printed version i made a bolt on mount to go with the bottom mount

Added Truck Swamp Cooler

• This adds a little less the a 1/4" Tab at the top for Flat Glass Vehicles, That have a full frame around the window. This should stick into the window track at the stop to give a little extra strength

8/18/2025:

• Swamp Cooler required a bigger gap for window fit, and it was too tight again the drop rail. So i have adjusted this (Swamp Cooler Short Thin V3, Swamp Cooler Thin V3)

8/18/2025:

• Added Skinny Swamp Cooler and Hat. This is a 6" Tube version and also set to 250mm height for smaller printers. Design is scalable to preferred height, just make sure you on scale the height
• Updated All Hats, Short and Thin Hats had too much wiggle room, Wanted a firm fit, so new hats are only .02mm bigger then the tube (V3)

8/17/25:

• Added a thinner version of the Hat with bigger honey comb grille that designed to pop out more :)
• Added a shorter Hat (65mm vs 80mm)

8/16/25:

• Added Thin Version - Thinned the walls from 20mm to around 10mm.... Print Settings

Printer Brand:

ELEGOO

Rafts:

Supports:

Resolution:

Infill:

Filament Material:

Notes:

Category: 3D Printing