1 / 8
iPod Classic 5th Gen thin USB-C Case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a proof of concept for a case that encloses a 30-pin to USB-C adapter for the iPod Classic (5th / 5.5th thin)
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 618
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (10)Powiązane
This project is a proof of concept for a case that encloses a 30-pin to USB-C adapter for the iPod Classic (5th / 5.5th generation). Wanted to explore a reversible way of adding USB-C without soldering or opening the iPod.
The adapter slots into the print and is held by four M2×4 mm screws. The USB-C port aligns neatly with the iPod’s original connector, the result is a case that adds extra length but hey usb-c.
Details:
- Reversible mod, no soldering required
- Holds a 30-pin to USB-C adapter securely
- Two-part print, assembled with four M2×4 mm screws
- Adds about 1 cm to the iPod’s length and 3mm to width and depth
Print Settings
- Material: PLA, PETG, or ABS
- Layer height: 0.2 mm
- Infill: 15–20%, make it as heavy as you want...
- Supports: Required (recommended under the port cutout and screw posts)
Total Materials
- 1 × 30-pin male to USB-C female adapter (inexpensive eBay/AliExpress type)
- 4 × M2×4 mm screws
- 3D printed base and lid
Notes
- This is a design exercise intended to test the concept of an external USB-C enclosure for the iPod Classic.
- Designed for iPod Classic 5th/5.5th generation thin version.
- The case adds extra bulk. Consider it a proof-of-concept rather than a refinement.
- Adapter quality varies; many are charge-only, some allow syncing.