Snug-Fit 4U 6" or 10" Mini Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
6" or 10" mini rack "legs". Rack mounts you install are the lateral supports.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 293
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
6" or 10" mini rack “legs” originally modelled after some monitor stand legs I needed to reduce the height of my monitor stand.
Rack mounts you install are the lateral supports. I was only allotted a small space at the bottom of an IKEA cupboard to put all of the networking equipment for our house. The other options that I really liked extended a little too high above or below the actual rack unit heights, so I needed one that would do 4U with only a few mm above and below to fit the space.
I have not tested 6" but I'd imagine it'd work just fine.
I have included the freeCAD file for this project, but it is by no means parametric so you'll have to change the sketches yourself, or please ask for any requested changes if you like the model and I'll see what I can do if I have time.
This isn't the strongest rack, and in future I might add triangular supports if I add heavier equipment.
You can add a third leg and have two racks side by side which I might do in future.
Hardware: M6x16 screw head bolts, though would likely look nicer with torx/allen bolts rather than philips/JIS/flat head.
Originally designed to press fit the hex nuts behind where you screw into, I discovered that the M6 thread actually just screwed straight into my PETG 3D printed holes so I didn't end up using that feature and you'll likely need a clamp or vice with a flat plate to press them into place.