1 / 2
Lian Li A4-H20 bottom fan shroud and riser
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Riser to add two 92MM fans to the A4-H20.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 177
- Wydruki
- 0
- Wyświetlenia
- 1305
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 3)Remiksy (2)Kolekcje (13)Powiązane
A riser to allow better airflow and the addition of two 92mm slim fans to the bottom of the Lian-Li A4 H20.
The hole in the bottom of the case is roughly 92mm wide so it didnt make sense to use larger fans as they would just be pushing air into the middle of the case.
Be careful your PSU cables dont push against the grilles to aggressively as they can make the grille rub on the fan blades a bit.
To print on a smaller printer (P1P) I used the bamboo software to slice it between the two fans and add a couple of alignment pins and printed half at a time.