Nerf Maverick absolver and pen holder.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an adapter for a cylinder from a Nerf Maverick for absolver/ pencil holder
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is an adapter for a Nerf Maverick cylinder to allow it to connect to a 3/4-in PVC pipe Connector piece that is 28mm-ish and allows it to connect to a modified drain blaster or similar item, as well as providing a flat base to use a Maverick cylinder as a pin/pencil holder. This is my first model ever, and it isn't Great, but as one of my favorite YouTubers north of the Border says, “It's not good, it's good enough”. After fiddling around with the design a bit, since you have to take out the air restrictors for this, I realized it works perfectly for holding pencils on my desk when not in use. Print out the optional piece for the removable base for when in pencil holder mode.
( note. Do not glue the optional base for when in pencil holder mode, As it needs to be removed when going to be used as a absolver. Make sure to glue the PVC pipe connector into the 3D printed part for the absolver ONLY, else it will shoot out of what you use to blast it. I used a modified drain blaster.)
last updated august 31st 2025, to add additional STL files and corrected files.