1 / 3
RunCam Spotter V2 FPV Camera Mount for 30mm Cooling Fan — zdjęcie 1
1 / 3

RunCam Spotter V2 FPV Camera Mount for 30mm Cooling Fan

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

FPV Camera mount with cooling fan.

Ocena
5 / 5
Polubienia
8
Pobrania
79
Wydruki
1
Wyświetlenia
355
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

This small FPV camera is usually meant to have cool air passing by it when mounted on a RC drone or plane. I wanted to mount it on my RC crawler and had a 30mm fan in my leftover electronics box. 

Center distance of the fan holes is 24mm. Fan is standard 30mm x 30mm sizing that is supposed to run on 12 volts. I have it plugged into my servo rail and only give it about 6V and it works fine. 

I printed it in Bambu Lab ASA. I would recommend a high-temp filament due to the heat this camera with built in transmitter can create. 

I also included a small shroud cover to try and force more of the fan output to the heatsink, that is glued on with superglue. 

I just slid the camera in place, routed the camera power wires through a small cutout on the bottom, screwed the fan on with two screws, then glued the shroud in place. The fitment is meant for this RunCam V2 Spotter camera and transmitter combo. I used a little bit of glue on the camera power wires to help hold it down, but otherwise it's a snug fit. 

.STEP (for customization) and .STL files included.

Camera link: https://www.amazon.com/dp/B0CSJPDPHQ?ref=ppx_yo2ov_dt_b_fed_asin_title

Tagi