Ender 3 Dual Z Belt Tensioner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ender 3 Dual Z Belt Tensioner
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 244
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Edit - This works but I stopped using it because I found that it's not needed when using a 610mm belt, with modified upper z-screw bearing blocks. The blocks are similar to the ones that come with dual-z screw kits, but modified to allow them to be secured to the vertical aluminum extrusions instead of only the horizontal extrusion at the top.
This is a tensioner bracket that I made for my Ender 3. After installing a dual Z kit (extra stepper and lead screw) I found that when turning off the machine, the difference in weight of the gantry on the side with the hotend parked at it and the opposite end caused the Z axis screws to become out of sync. The side with hotend would drop very slightly, and after a few prints, there would be a mm or two difference in left and right sides.
This helps keep them in sync and works quite well.
Extra parts needed for tensioner:
1x M3x20mm socket cap screw
1x M3 Nyloc nut
2x M3x10mm socket head screws
2x M3 T-nut
2x M3 x 9 Socket cap screw
2x 5x14x5mm flanged bearing - can be found here: https://www.harfington.com/products/p-1059178?variant=42151364886777 (I included a model for a bearing alternative that should work fine as long as you don't tension it very tightly.)
I also included a model for an insert in case you use bearings that have an 8mm bore.
Parts for dual Z belt:
1x 610mm closed loop GT2 belt, 5mm width
2x 20-tooth GT2 pulley with 8mm bore (can be printed, but I found that the teeth don’t grip the belt quite as well as with metal pulleys)
This kit has these both of these, BUT, it requires that the pulleys be drilled out to 8mm bore. This is a bit of a pain when gripping the aluminum tightly enough to not spin while drilling. If you have a way of doing this, then it's likely the cheapest way of adding pulleys to your Ender 3 Z axis. https://www.amazon.com/dp/B0C1NBYWRL?ref=ppx_yo2ov_dt_b_fed_asin_title