1 / 5
Lezyne GPS Bike Mount with Reinforcement Channels — zdjęcie 1
1 / 5

Lezyne GPS Bike Mount with Reinforcement Channels

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lezyne GPS Bike Mount remixed with internal channels for metal reinforcement strips.

Ocena
0 / 5
Polubienia
1
Pobrania
25
Wydruki
0
Wyświetlenia
131
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Printables re-post of a remix I created and posted to Thingiverse on 2020-10-31: https://www.thingiverse.com/thing:4639170

I tried printing the source model by @Mattwall, but I found that layered 3D printing does not lend itself well to being clamped by metal bolts.  So I rebuilt the model from scratch, mostly following Matt's design dimensions, but with added internal channels for inserting metal reinforcement strips.

The design is updated to use M4 bolts and nuts.  For the bolts, I used M4 Hex Button Head Cap Bolts (304 SS). For the nuts, I used M4 x 0.7mm Nylon Lock Hex Nuts (also 304 SS).  I've added a dimension photo for helping you figure out what length you need for your application, as your bolt length may vary depending on how thick you make your metal reinforcement strips.  The handlebar hole diameter in the model is 27.2mm, designed to fit a 25.4mm (1 inch) handlebar with a small margin for handlebar tape or rubber wrap for padding. The internal reinforcement channels are 7mm wide by 3mm high.

I have "bridged" the bolt shaft holes just above the hex nut recesses to support FFF printing without supports inside the nut recesses. I used a drill to quickly open the holes after the bracket was printed.

Finally, there is a second set of STL files labeled "with-supports" which is how I printed them. I liked the surface finish better with my own custom supports (which I cut off with a knife afterwards) better than the default supports that Simplify3D creates.

Tagi