Lectric Elite to Head Tube Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Elite Headlight has a tendency to break at the bottom mount point. This fixes the problem holding the whole housing.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 486
- Wydruki
- 4
- Wyświetlenia
- 2049
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
I have a Lectric XP4 with the Elite headlight. Like so many others, my light snapped at the mount. I super glued it as a temporary fix before designing this. I hope you like it.
Photo of light on the wall is 25' from light to wall. Top of beam is 30" from the ground.
Print Instructions:
This is what I did for mine. You can try other settings. YMMV
You need a print area of at least 107 x 127 x 101
Load into slicer, put flange face down on the plate and cut the object at 4.02mm above and parallel to the build plate. Set objects so they stay in the same place.
Set walls on the mounting flange to 10 walls. Yes, that's a lot but trust me. You want the strength around the bolt holes.
Set 5 walls for everything else.
TREE SUPPORTS ON BUILD PLATE ONLY
.4 Nozzle @ .2 layer height
Gyroid infill at 15%
I used Creality Hyper ABS on a K1 MAX. I would recommend ABS or at least PETG
Installation:
Install the top 2 bolts first. You want them snug but not tight.
Run the headlight wire through the main opening and down through the gap between the 2 flange halves. (see pic of top down view)
spread the bottom of the mount apart and press the Light in.
Install bottom 2 bolts and tighten all 4
Lastly get used to having a headlight that always points forwards. It can feel a bit odd at first.