1 / 1
LEGO PART 6595 - Wheel 49.6 x 28 VR (36.8 x 26) with Axle Hole — zdjęcie 1

LEGO PART 6595 - Wheel 49.6 x 28 VR (36.8 x 26) with Axle Hole

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

LEGO wheel with an integrated axle hole, commonly used in Technic sets for vehicles such as cars and trucks

Ocena
0 / 5
Polubienia
4
Pobrania
31
Wydruki
0
Wyświetlenia
174
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Works in PLA using 0.15 mm layer height with structural settings. For a smooth finish on the outer rim, enable ironing. 

I modeled this part as good as my skill set allows to copy the original design.

Printing notes

The back side can be tricky because it has many small corners and holes. I recommend enabling organic supports with the following custom settings:

  • Top contact Z distance: 0.2 → Gap between support and model; larger = easier removal, smaller = cleaner underside.
  • Pattern spacing: 3 → Distance between support lines; higher = weaker, easier to break off.
  • Top interface layers: 2 → Layers between support and model; more = smoother surface, harder removal.
  • Don’t support bridges: ✓ → Skips supports under bridges; bridging algorithm usually handles them fine.
  • Preferred branch angle: 35° → Angle of support branches; higher = wider spread, easier to detach.
  • Branch diameter: 1.5 mm → Thickness of small branches; thinner = easier removal.
  • Branch diameter with double walls: 3 mm → Thickness of stronger branches; balances strength and removability.
Updated
  • Reduced the width of the outer edge after taking the picture

Tagi