KitchenAid Artisan Rotating Propeller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rotating aircraft-like propeller for the KitchenAid Artisan home mixer.
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 612
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
Inspired by llamboladd's Spinning Daisy found on Thingiverse https://www.thingiverse.com/thing:5229296 I modified Jozarth's static prop into a spinning prop. This completes the military aircraft theme of the mixer.
Shaft and prop were printed in PLA+. The Shaft has an 80% infill for strength. Utilized a brim to ensure it didn't fall over. The hub was printed with PETG, with supports (Larger diameter up) as the mixer has a clamp screw, and finally the prop was printed nose cone up (see photo) in PLA+. The blades were hand painted to reduce print time of multicolor item.
After all items were completed, some assembly is required. See photo
- As each printer performs differently, test fit the shaft to the propeller, it is a tight fit, sand shaft or prop attachment if needed. On the Anycubic Kobra S1, it popped right into place.
- Place the Driveshaft through the hub
- Glue the propeller to the drive shaft.
The stickers are available via various on line shopping sites.