Utility Buckle V2 - For Paracord Bracelet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A lightweight buckle for your paracord bracelet with a standard 1/4'' hex bit storage and screwdriver
- Ocena
- 5 / 5
- Polubienia
- 55
- Pobrania
- 218
- Wydruki
- 1
- Wyświetlenia
- 894
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This buckle is a convenient way to make sure your never caught without a screwdriver, or rope for that matter. The buckle stores a hex bit of your choosing.
This buckle is comparable in size to a standard 5/8'' buckle that you would traditionally use for a paracord bracelet and is designed to be used with 550lb paracord
For the paracord bracelet, I recommend using a double cows hitch to get a 4 strand base. Keep the base of the bracelet as a separate piece of cord, as this allows you to frequently remove the main length of cord without having to resize your bracelet every time. I typically do a cobra knot pattern over the top as shown in the images. Check youtube for tutorials on how to do these, they are quite simple and take little time.
PRINT SETTINGS:
I highly recommend printing this buckle out of either PETG or Nylon filament, as the clip requires a good amount of flex, and both also provide good impact and abrasion resistance for when your out and about.
Print in original orientation
female side can print without supports but may need a little underneath the cord hole.
male side does well with automatic tree supports
0.2mm layer height
3 walls/top & bottom surfaces
15% infill (very little of the model has space for infill so a higher number makes little difference)
NOTE: this is a screwdriver made from plastic, you are not going to be able to torque screws down with all your might, but it is still incredibly handy in a pinch to undo, or retighten screws on the go.