Sinclair ZX Spectrum 16/48k Replacement for Original Polystyrene Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sinclair ZX Spectrum 16/48k Replacement for Original Polystyrene Box
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 231
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Sinclair ZX Spectrum 16/48k Replacement for the original polystyrene inner
Most of these inner polystyrene boxes have seen better days, often broken or suffering from the dreaded Plasticiser Migration which leaves a mess on the cables that could posisbly damage them.
This 3D printed replacement has the same dimensions as the original so fits in the cardboard outer fine. It also has some small improvements such as a holder for the plug socket and better access to the cassettes. Everything should fit as it does in the original.
Main downside vs. the original is it is a lot heavier using around 700g of filament with 10% Adaptive Cubic in-fill*, whereas the original weighs just under 100g.
I've created two versions, one for larger printers which prints in one go and one for smaller ones with dovetail joins. These are surprisingly strong, so much so that I didn't need to add any glue. I've used a 0.1mm tollerance which works fine on my Bambu P1S.
*I print with 0.2mm layer height with 10% Adaptive Cubic in-fill and Infill combination on. I've tried many in-fill settings to get the filament usage and print time down and found this to be optimal. Would be happy to hear if there is a better option that results in a strong but light print.