Inissia capsule container with holes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Same model but with holes to match the look of the original part. Holes are a little smaller than they should be. :)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 75
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
I printed with both PLA and ABS with default parameters on a Bambu P1S and both turned out fine. Printed upright, e.g. with the drain facing down and the plane with holes perpendicular to the build plate. I did have supports on, they only print under the lip around the base, but nowhere else. Holes turn out a little flat, but good enough.
You can also print with the holes face down, which will give you better circles, but then you need supports for the inner overhangs of the back plane.