Bicycle Mount for 24oz Owala Bottle

This is a bottle cage designed to accept the 24-ounce Owala bottle. The Owala bottle is extremely heavy, lacks any ridges to retain it by, is very tall compared to a typical sports bottle, and it needs extra vertical space in order to be drawn and reholstered. This means that it may not be compatible with your bicycle, and you need to choose the mount offset that maximizes the vertical space the bottle has. The "very-high-mount" version is the original, and I designed it to fit on my Ride1Up Roadster V3, whose only bottle cage mount is on the seat tube. Its screw holes are offset 90 mm from the floor of the cage. All other bikes will very likely require one of the lower mount offset options. To find what offset your bike requires, hold the bottle against your cage mount and slide it downward until it clears all parts by about a finger's width, then measure the distance from the bottom of the bottle to the middle of the lower cage screw. Use the offset closest to that without going over, or make the exact one you need using the FreeCAD parametric file. If you cannot fit the Owala bottle into the available space with an inch or two of headroom above it, this product is not compatible with that mount on your bike.

"very-high-mount": 90 mm
"high-mount": 70 mm
"mid-mount": 50 mm
"low-mount": 35 mm
"very-low-mount": 20 mm

To holster your Owala bottle in the cage, rotate it so that the bottle's waist faces towards and away from the cage mount; in other words, place it so that the side clamps attach to the widest part of the bottle, not the bottle's waist. The cage can properly retain the bottle if it's off from that position by ±45°, if it is outside of that, the clamps cannot retain the bottle by its waist. Depending on the fitment produced by your printer, the bottle may rattle in the cage over bumps. One layer of thin electrical tape, tightly wrapped into the inside of the bottom ring and the upper clamp, will increase the retaining power significantly and reduce rattle.

This cage is not intended for mountain bikes or other use cases where the bottle will be subject to extreme forces, as there is no positive vertical lock in the cage design. Please get the proper bottle cage and bottle for that.

Print without supports using a 0.4 or 0.6mm nozzle. Use 20% infill and enough walls that the parts other than the stiffeners of the clamps and the cage mount are entirely walls. Ensure that the Z-seam aligns with the cage mount; in the default orientation, that means putting the Z-seam on the Right.

This model is my work but is being reuploaded from my Thingiverse account - https://www.thingiverse.com/thing:7131058