1 / 10
Ares 3D-Printed Two-Way Loudspeakers / Speaker Enclosure — zdjęcie 1
1 / 10

Ares 3D-Printed Two-Way Loudspeakers / Speaker Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is Ares a HiFi 51Hz Tuned speaker made by me. No supports required! (Two Versions + Terminals)

Ocena
0 / 5
Polubienia
16
Wydruki
0
Wyświetlenia
909
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Audio
Licencja
Standard Digital File License

This is a project I worked on some time ago for someone. The goal was to create an efficient speaker that delivers deep, Beautiful/Neutral Sound, perfect for enjoying a wide range of genres. This two-way speaker reaches an impressive depth of 50 Hz!

The Speaker has 6L Volume, its boxy shape allows it to have much Air Volume so it can achieve playing 51Hz deep at F3 (Not even Included Room Gain)

Down below are Two Versions, Hulled means you can put something in like plaster of paris for example (Watch DIY Perks for that) Other Version is not Hulled and can be used instantly.

The speaker drivers used are:

SB12PFCR25-4 Woofer

SB19ST-C000-4 Tweeter

Terminal Binding Posts

Tutorial:

There are 3D-printable terminals down below that look nice and can be easily bolted into the enclosure using M3 screws. Be careful to only tighten them lightly, as the enclosure is plastic.

The baffle includes slots for four M3 and M4 nuts. To assemble, install the drivers into the baffle, place a nut into each slot, insert the matching screw, and tighten it just enough to hold everything in place. Once all components are aligned, securely tighten the screws.

For the front, use M3x16 and M4x16 screws for the Woofer and Tweeter.

Apply silicone or any non-quick-drying adhesive into the groove to ensure a strong bond between the enclosure and the baffle.

Crossover:

I designed my own crossover based on online measurements. Although I don’t have real-life measurements, the speaker already performs quite well. If you notice differences between the schematic and the listed component values, always refer to the values provided in the Components section. These adjustments are minor tweaks intended to improve linearity.

All components, including the drivers, were sourced from SoundImports.eu

Crossover Components:

Resistors: R2 7.5 Ohm, R1 4.7 Ohm.

Air-coils: L4 0.12mH, L2 0.68mH, L1 0.1mH.

Film-capacitors: C5 8.2uF, C3 2uF, C2 4.3uF, C1 6.8uF.

Updating:

I plan to update this design in the near future, so be sure to check back for updates!

Last updates: 

 

 

 

Tagi