Ikea UTÅKER Stackable Bed Raiser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
NOTE: I make no claim or warranty about safety or stability of these. You use them at your own risk.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 177
- Wydruki
- 1
- Wyświetlenia
- 2205
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
NOTE: I make no claim or warranty about safety or stability of these. You use them at your own risk.
I had Bought this bed from Ikea: http://www.ikea.com/us/en/catalog/products/30360487/
Turns out the mattresses they displayed with it were about an inch too tall for the beds to properly stack, so I made these risers to fit between the beds to accommodate the added mattress heights. They have a side with a hole for the top beds peg to fit into, and a peg on the opposite side to fit into the bottom bed's hole for stability. I also gave them the same curvature as the bed legs to blend in ascetically. They give a 1.5" rise so you can comfortably accommodate a 6" mattress instead of a 5" mattress when stacked.
I printed them with 65% infill because I was paranoid about the sturdiness and support in case someone accidentally sat or jumped onto the stacked beds while I had the risers in there.
_____________________________________________________________
If you enjoy the models we have made and shared with the community, we encourage you to consider supporting us. You can make a contribution here: https://www.dariranch.com/product/3d-model-design-donation/