Keyhole stud hooks for IKEA Skadis
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hooks and adapter plates to hang devices with keyholes on an IKEA Skadis board
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 103
- Wydruki
- 0
- Wyświetlenia
- 465
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to mount my home networking equipment on an IKEA Skadis board but I couldn't find models with studs that would fit the keyholes on my router/switch/etc.
NEW! skadis stud - parametric
I designed this model to generate studs to fit an arbitrary 2-stud pattern/offset. Set the x/y distance between the keyholes, and the stud dimensions, and it will generate adapters to fit those keyholes to the Skadis board. It can also generate generic pegboard-compatible studs too!
Usage for Skadis board: This should be fully parametric to support any stud spacing. Set the 6 stud_* parameters and the model will automatically update for you.
Usage for generic pegboard: Note: The generated model has not been tested with a real pegboard yet. First, suppress the “Skadis Pegs” selection set and unsuppress the “Pegboard Pegs” selection set. Follow the steps for Skadis board above. Configure the pegboard_* dimensions - as written it's designed for an imperial (1"/25.4mm) metal pegboard. Finally, set is_skadis to false to generate pegs at the pegboard spacing instead of Skadis spacing.
Skadis_Stud
This is an adaptation of the excellent CSD_Salzburg shelf hooks to replace the hook part with a stud. I simply modeled the stud, then in my slicer I cut the hook off of the CSD_Salzburg model and joined the stud to it.
The stud is 6mm deep overall, with a stem length of 2mm and head thickness of 4mm. The stem itself is 4mm in diameter, and the stud head is 9mm diameter. I sliced off part of the stud to enable printing without supports but it still seems to hold well.
Printed flat in PLA.
Skadis_Stud_Plate
This is my own design, but designed to mount on the CSD_Salzburg shelf hooks. This can be mounted with the studs at the top or the bottom, using any combination of holes that matches up with the board. I chose the shelf hooks over the universal hook because they are lower profile, and I chose to print the hooks separately so that I could print them in their strongest orientation.
The STL specifically has studs that are 3.2mm deep, with a 1.2mm stem. The stem is 3.8mm dia, and the head is 7.8mm. The studs are 110mm apart, and the Skadis hook holes are 20mm apart.
I've also included the f3d file so you can adjust the parameters to your liking.
Printed with the studs on the build plate so the layer orientations are not shearing with the load. PLA seems fine.
skadis studs - CyberPower UPS 450VA
Studs generated using my parametric model to fit the Cyberpower SE450G1 UPS. The stud spacing is 2.25" x 4.5".