1 / 2
Makita 14.4 volt nicad battery replacement adaptor — zdjęcie 1
1 / 2

Makita 14.4 volt nicad battery replacement adaptor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Recycle your old 14.4 volt Makita tool with this adaptor to use 18volt Ozito or Einhell batteries.

Ocena
0 / 5
Polubienia
5
Pobrania
22
Wydruki
0
Wyświetlenia
217
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

Recycle your old NiCad Powered Makita battery drills. 

 I was given this 14.4 volt drill and the NiCad battery's by a builder who was moving on to Lithium battery based tools.  The NiCads for the old drill was well past Its use by date, so they went to Bunnings who accept them for recycling.  This left the battery drill.  So it either either gets disposed of or I recycle it.  I tested the drill at 20 volts on a power supply and it worked and no smoke!.  A testimony to Japanese build quality and their engineering margin.

 Worst case it it will eventually fail, or maybe not, so there is nothing to lose.  The component which could fail is the variable speed trigger, in these tools the trigger was made by Omron and marked at 15 volts for both the 14.4V and 12V drills.

I printed the adaptor in ASA (ABS and PETG will be OK as well) using paint on organic supports and 30% infill.

It is necessary to cut part of the drill case to get the battery to sit in close, I put the adaptor in and used it as a guide to cut, file etc. The yellow highlighted area shows the cut finished.

The slots for the connectors are 1mm thick and 15mm wide, I used 0.5mm copper which I tinned with a soldering iron.

 Solder the other end of the wires onto the contacts for the battery in the drill, check positive and negative against the old NiCad battery.

The connectors are inserted from under the adaptor and held in place with a pan head screw.

Remove two screws from the bottom of the drill handle then split the case slightly to insert the adaptor.

Put the screws in and turn them backwards (counter clockwise) until you feel them drop a thread depth then screw them in , this stops you cutting a new thread.

Tagi