Cable reel stand attachment for the "Universal Filament Spool Reel"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an attachable stand for a universal filament spool reel which comes without a stand.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 510
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Disclaimer: Only the part printed in orange PETG is from me and only this file is provided here. For the Filament spool reel see the linked page.
I've created this reel stand attachment for the "Universal Filament Spool Reel" by the user @steriku because I wanted to be able to place the reel with a rolled up network cable and use it like a cable reel.
You can find the instructions for the reel on the linked site.
The stand is printed with 3 perimeters from PETG with 25% Gyroid infill and is sturdy enough for this use case. You will need two heat-set threaded inserts with M4 thread and, two M4 washers and 2 M4 screws with a minimum length of I would say at least 18mm. The total length from left to right outer wall of the top of the holder amounts to 22mm. I've used allen screws but you could also use countersunk screws.
To assemble the two parts, you will need to drill two 4mm holes in the reel holder where the screws will go through.
To achieve the cable reel functionality for the network cable, I've cut a hole into the side of the filament spool, glued on of those RJ45 couplings from deleyCON (no advertisement - I get nothing from this, its just for information purposes) to the spool and connected one side of the cable to it.