3/8 Cup Scoop - No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a scoop or cup for measuring approx 3/8 of a Cup
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
This is a scoop or cup I designed to measure approximately 3/8 of a cup. This need arose when my children were over feeding the cat its special dietary food.
This cup will hold approx 88g and does not need supports. However, this can be a challenging print due to the low bed adhesion on the handle section. It can also fail when the two sections are joined at layer 188 at 0.2mm height. These failures happened on my old Ender 3 until everything was dialed in perfectly. Moreover, the Core ONE printed it without issue on the first try using the default PLA “Balanced” settings. It may be a good test print for printer calibration.