OMVS Mini - Open MVS shell for Neo Geo MV1C
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix/rebuild of the excellent OMVS shell made by Avram. My printer wasn't big enough to print the shell in…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 159
- Wydruki
- 0
- Wyświetlenia
- 1713
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
This is a remix/rebuild of the excellent OMVS shell made by Avram. My printer wasn't big enough to print the shell in one part so I designed a new shell that is printable on a Prusa i3 MK3 sized printbed.
All OMVS parts are completely compatible with this shell, except for the power LED for which I omitted support for in my design.
For materials, you'll need:
- two M3x2 bolts to lock the AV board in place
- six M3x4 bolts to lock the MV-1C and OMVS controller board in place
- four M3x4 bolts to lock the shell
First, screw in the OMVS Power connector and the AV port. Connect the MV-1C to the Power/AV and place it on the bracket. Bolt it to the bracket. Tape the OMVS acrylic sheet to the shell and close the system up, making sure that you start with the controller ports and on/reset button. It's a tight fit, you can bend the rear of the shell a bit if it won't go over the bracket. Use the remaining bolts to button it up and enjoy your OMVS :-)
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
20%
Filament: Prusament PLA/PETG Lipstick Red
Notes:
The bracket doesn't need supports when printed with the flat side on the bed. It's a big surface, so make sure you clean your printbed well with soap and water and use 3D Lac to make sure the edges don't curl upwards.
The shell is best printed with the face of the MVS logo on the bed, that way you will only need support around the cartridge slot and the logo will come out crisp and neat.The openings for controller/AV/power and buttons in both the shell and bracket print fine without support, but feel free to support those aswell if you find that your printer doesn't handle bridges well.
Category: Video Games