Waveshare PCIE TO 4-CH NVME Board (B) Din rail mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Din rail for waveshare 4x PCIe board https://www.waveshare.com/wiki/PCIE_TO_4-CH_NVME_Board_(B)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 212
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
DIN rail mount for waveshare 4ch nvme board, using m3 heatset inserts. Maintains the original Waveshare FPC and power cable to the rpi5. DC connector also fully usable.
uses Maxstupo 51mm din rail clip which I've also included in this models files (https://www.printables.com/model/537942-din-rail-clip-heat-insert-versionhttps://www.printables.com/model/537942-din-rail-clip-heat-insert-version)
This does NOT screw to the rpi5, so will also need a horizontal rpi din rail mount (i've used https://www.printables.com/model/83110-raspberry-pi-horizontal-mount-for-din-railshttps://www.printables.com/model/83110-raspberry-pi-horizontal-mount-for-din-rails, but any would work if it puts the rpi centered on the rail center line), or you could use a longer FPC cable.
It looks like the DIN rail clips might not be centered with the din rail so if you get a FPC cable mis-alignment, it might be worth rotating the din clips around. you can see it's slightly out on one of my photos but functions fine.