Split Loom Clips for OpenBuilds V-slot Extrusions
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This/These are wire-loom clips that fit into OpenBuilds V-slot extrusions, used in quite a few 3D printers. They allow…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 230
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This/These are wire-loom clips that fit into OpenBuilds V-slot extrusions, used in quite a few 3D printers. They allow you to clip the wire bundles to the printer frame.
There's a few on here, but the ones I'd found for 1/2" split-loom were too small, seeming to target 1/2" outer diameter, rather than 1/2" inner diameter.
The initial one uploaded is 17mm inner diameter, which fits the common half-inch plastic split-loom wire wrap. Its 1.5mm thick, sized specifically to print tightly with two shells with a .4mm nozzle, and thin enough to still be flexible even in PLA to fit around the wire bundle.
The model is parametric, so I'm happy to upload other sizes if needed. Just post a request in the comments. I need to take some measurements, but I'll also be uploading one for 1/4 split loom, asap.
Edit: Added a 10mm inner-diameter one, which fits 1/4" split loom.
Edit 2: Also added a 13mm one, which fits 3/8" split loom.
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Mk2
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.2mm
Infill:
n/a
Notes:
I'm printing these with two perimeters, .2mm, which makes them solid in a .4mm nozzle.
Category: 3D Printer Parts